HSD130 Hypertherm Plasma Torch Consumables For Hyperther Plasma Cuttting Machine

HPR130 / HPR130XD Hypertherm Plasma Cutter Consumables For Plasma Cuttting
 
            We can offer you all plasma consumables for hyptertherm, Kjellberg, Esab, Koike, Komatsu, Thermadyne, such as: electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body and so on.
           Each of our products has been tested with a rigorous precision instrument, A large number of piercings tests and service life tests, And made batch trial in our customers. If all results are good, then we will producing them.
        
     

 
 

 

Technical Support:
 The problem of plasma cutting

5.1 no high frequency guidance arc

Check high frequency arc ignition circuit, first check the 110VAC, and observe the G1, G2 whether there is discharge sparks exist. If not, generally 110VAC did not come or fixed G1, G2 plastic board damp, damp after G2, G1 can not discharge and produce high pressure. Drying wood glue with a hair dryer to restore 110VAC. If there is still no guide arc, should check the high frequency arc, due to the high frequency of the skin effect, the high frequency line and the nozzle of the conductive ring is not good or because of the reasons for the sealing ring and the cooling water will not have a short circuit. Open the cutting gun, tighten the high frequency line or replace the sealing ring, generally can solve the
HSD130 Hypertherm Plasma Torch Consumables For Hyperther Plasma Cuttting Machine